McGREGOR MEC18352 - Step 5 Connect to Power Supply; Step 6 Locate Chain Brake

18
Step 5 Connect to power supply
Prepare
Insert the power cord/plug to power supply before starting to work.
The motor will not start if the chain brake is in the engaged position.Disengage the chain
brake level by pulling backward toward the front handle.Keep brake setting is in correct
position before using,and ensure chain saw operate normally.
Step 6 Locate the chain brake
Brake disengage
Brake engage
Customer Helpline 0333 300 1614
Make sure the chain brake is in the operating positon before using.To check brake
operation:
:
3ODFHWKHVDZRQDILUPIODWVXUIDFH
6WDUWWKHVDZEULHIO\
.HHSWKHOHIWKDQGRQWKHIURQWKDQGOe and roll the left wrist to move the front handle
guard forward to manually activate the chain brake.