16
Customer helpline 0345 605 2065
Maintenance
Maintenance
WARNING:
If the supply cord is damaged, it must be replaced by the same cord provided by the
manufacturer. Also replacement of cord has to be done by the manufacturer, or its service agent
or similarly qualied persons in order to avoid a hazard.
CLEANING
Disconnect from electrical outlet. Using a soft brush-remove debris from all air intakes and cutting
blade.
Wipe over surface of your Hedge trimmer with a dry cloth.
WARNING!
Never use water for cleaning your Hedge trimmer. Do not clean with
chemicals, including petrol, or solvents as this can damage your hedge trimmer.
LUBRICATING THE CUTTING BLADE
For easier operation and longer life, lubricate the cutting blades before and after each use. Before
lubricating, make sure your Hedge trimmer is disconnected from electrical outlet.
Apply the gear oil so that it runs between the two blades.
AT THE END OF THE CUTTING SEASON
Clean your Hedge trimmer thoroughly.
Check that all nuts and bolts are secure.
Visually inspect the Hedge trimmer for any worn or damaged parts.
TO STORE YOUR HEDGE TRIMMER
Ensure the blade sheath is tted before storage.
Store in a secure, dry place out of the reach of children, and your trimmer can be protected from
damage.
Do not place other objects on top of the machine.
To Next Page
