McHammer Hurricane-1500 User Manual

751-082
User`s manual CarAmplifier
McHammer “Hurricane-1500”
power max. 4x 375W
power rms 4x160Wpower mono
power mono bridget 1200W / 4Ohm/1kHz
frequency-range 1O-40.000Hz ±1 dB
signal to noise ca. 85dB
distortion-factor <0,05%
bass range 0-12dB
treble range 0-12dB
speaker outputs 2 - 8 Ohm, 2ohm stabil
Indicator LEDs for Power +
Protect safety,
VU-Levelmeter
measure 43x28,2x5cm
Iaccesoires screwset & replaceble
fuse
Introduction
Dear customer,
Congratulations to this highclass
carhifi-product!
With this model you have chosen best quality united with futuristic design
and innovative functionality.
Please read manual carefully and act so,
to become full pleasure of your new audioamplification.
Installation
Please choose well-ventilated place in the car for installing the amplifier for preventing heat accumulation!
if you have no experience with installation of your amplifier, please use the help of an authorized car-hifi dealer
in your neighbourhood.
Attach the loudspeakers before connection of the current supply please. Neglect of the fitting instruction can damage
the amplifier.
Signal-Inputs
! Low-Ievel signal (Cynch-input): is best audio quality. If your car-radio has an preamp output it`s advisable to use
low-level input! .
! RCA - output connectors
! Adjusting the input-level (Gain control)

McHammer Hurricane-1500 Specifications

General

Brand	McHammer
Model	Hurricane-1500
Category	Car Amplifier
Language	English

Summary

Introduction

Installation

Signal Inputs

Low-level Signal (Cynch-input)

Best audio quality; advisable if car-radio has preamp output.

RCA Output Connectors

Connectors for audio signal output from the car radio.

Adjusting Input Level (Gain Control)

Setting the gain control for optimal input signal level.

Power Connections

Battery and Ground Connection

Connect B+ to battery, GND to car-chassis via shortest path.

Remote Connection

Connect Remote to switched +12V contact from car-radio.

Indicator Lights

LEDs for Power and Protect (safety, overload, short circuit, thermofuse).

Speaker Connections

4-Channel Stereo

Connect four speakers with 2-8 ohm impedance, minding polarity.

2-Channel Mono

Connect two speakers (subwoofers) with 2-8 ohm impedance.

Troubleshooting

No Sound

Check remote voltage, fuse, connections, speakers, and gain level.

Distorted Output Signal

Readjust gain level, check speakers condition and polarity.

Low Output Signal

Check car radio sound level, MUTE function, and readjust gain.

Blown Fuse

Check power connection polarity and for short circuits.

Noise Issues

Address noise from light generator or breakdown sparks by checking cables/power.