Connections
Connections
When the MCLK12 Power Control Input is connected
to a McIntosh Preamplifier or A/V Control Center
with Power Control Functions, the Clock’s Front Panel
Nomenclature and/or Meter Illumination can be re-
motely switched On/Off.
The connection instructions below, together with
the Connection Diagram are an example of a typi-
cal audio system. Your system may vary from this,
however the actual components would be connected in
a similar manner. For additional information refer to
“Connector and Cable Information” on page 5.
Power Control Connections:
1. Connect a Control Cable from the Preamplifier or
A/V Control Center Power Control Output 1 Jack
to the MCLK12 POWER CONTROL MAIN Jack.
2. Connect a Control Cable from the MCLK12
POWER CONTROL Out Jack to the Power Am-
plifier Power Control In Jack.
AC Power Cords Connections:
3. Connect the MCLK12 to a live AC outlet as il-
lustrated.
To Next Page
Loading...