Need help?Do you have a question about the McIntosh MDA200 and is the answer not in the manual?
General| Output Level Balanced | 4V RMS |
|---|---|
| Output Level Unbalanced | 2V RMS |
| Total Harmonic Distortion | 0.005% |
| Type | Digital-to-Analog Converter |
| Digital Inputs | Coaxial, Optical, USB, MCT |
| Analog Output | 1 Balanced, 1 Unbalanced |
| Digital Input Sample Rate (Coaxial) | Up to 192kHz |
| Digital Input Sample Rate (Optical) | Up to 24-bit/192kHz |
| Digital Input Sample Rate (MCT) | Up to 192kHz |
| Bit Depth | Up to 32-bit |
| Frequency Response | 20Hz - 20kHz (±0.5dB) |
| Signal To Noise Ratio | 110dB |
| Dynamic Range | 110dB |
| Standby Power Consumption | 0.5 Watts |
| Power Supply | 100 - 240 Volts, 50/60Hz |
| DAC Chip | Quad Balanced 8-channel, 32-bit Digital-to-Analog Converter |
Front panel display shows source, sampling frequency, volume, and setup modes. Intensity is adjustable.
Use as DAC for analog systems or as preamplifier with McIntosh source components and power amplifier.
8-channel, 32-bit DAC in stereo quad balanced mode for wide dynamic range and low distortion.
Digitally controlled attenuator system with tracking accuracy of 0.5dB.
Accepts coaxial, optical, MCT DIN, HDMI (ARC), and USB for PCM, DSD, Dolby Digital, DTS.
Rotates to select inputs and navigate menus. Can be pressed or held to access menus.
Receives commands from the remote control.
Adjusts output level or navigates menus and trims.
Receives operating data or sends remote control signals to source components.
Receives or sends On/Off signals to/from other McIntosh components.
Procedure to enter the setup menu by holding the INPUT knob.
How to navigate menus with INPUT knob and adjust settings with ADJUST knob.
View MDA200's unique serial number in setup menu or on the rear panel.
Check main and digital audio firmware versions accessible via the setup menu.
Set level to 'Fixed' for preamplifier pass-through or 'Adjustable' for volume control.
Return all settings to factory defaults by holding the INPUT knob.
Instructions for powering the unit on/off using the ADJUST knob or remote control.
Procedure to reset microprocessors by holding the ADJUST knob until LED switches off.
Diagram and description of buttons for power, volume, input, trim, and playback control.
Details frequency response, THD, output levels, S/N ratio, dynamic range, and impedance.
Lists digital input formats (PCM, DSD, DXD) and sample rates for various inputs.
To Next Page
