McIntosh MX151

23
8. Return to the “Speaker Configuration” Menu by
pressing the SETUP Push-button. Scroll down to
“Save Changes” by using the Downq Push-button
and then press the SELECT Push-button to save
the change. Refer to figure 18. If no changes are
to be saved, press the SETUP Push-button. The
“Confirm Exit” will appear On-Screen and select
“Yes”. Refer to figure 19 on the next page.
Note: Once changes have been saved, any additional
changes will first require selecting the “Edit/
Select” again.
Setup Mode
Speaker Conguration 
L M
C M
R M
RS M
RBS M
LBS M
Back 
Figure 12
Speaker Conguration 
AUX2 R -
AUX3 L -
AUX4 R -
Edit/Select
Verify Current Setup
Back

Figure 14
Speaker Conguration 
LBS M
LS M
SUB Sub 80
AUX1 L -
AUX2 R -
AUX3 L -
Back 
Figure 13
then press the SELECT Push-button. Refer to
figure 15. Press the SELECT Push-button again.
Refer to figure 16.
7. The “Select Perf.” Menu will appear, then use the
Upp or Downq Push-buttons to highlight the “L”
(for large) menu item for the Left Front Loud-
speaker. Then press the SELECT Push-button.
Refer to figures 16 and 17.
L 
Bass perform M
Bass cutoff 80Hz
Bass order 4th LiRi
Gain offset 0.0dB
Back

Figure 15
L 
Bass perform L
Bass cutoff 40Hz
Bass order 4th LiRi
Nat. roll-off No
Gain offset 0.0dB
Back

Figure 17
Select Perf. 
-
XXL
XL
L
M
S
XS
Custom
Back

Figure 16
Speaker Conguration 
AUX1/2 (L/R) -
AUX3/4 (L/R) -
Load Cong
Create New Cong
Save Changes
Abort (no changes saved)

Figure 18