Need help?Do you have a question about the mcmurdo S4 and is the answer not in the manual?
Defines manual scope and lists applicable SART models and options.
Details product revision history up to December 2004.
Lists specialized and routine equipment for SART servicing.
Guidelines for handling electronics to prevent ESD damage.
Summarizes hazards (battery, RF radiation, IPA) and precautions.
Details hazards and safe handling of lithium batteries.
Explains SART's RF output and safety during testing.
Outlines tasks for routine and advanced service agents.
Specifies monthly and annual testing frequencies and methods.
Describes the flow for assessing returned SART units.
Explains the purpose and use of the SART assessment form.
Instructions for checking casing, pole, lanyard, tab, and battery expiry.
Steps and equipment for performing the SART self-test.
Method for testing SART response to radar signals.
Procedure for testing SART frequency sweep using a tester.
Method using hot water to detect leaks by bubble escape.
Method using water immersion to detect leaks by weight gain.
Procedure to test battery voltage for proper operation.
Step-by-step guide for replacing the SART battery.
Lists common faults, causes, and recommended actions.
Instructions for replacing the O-ring seal.
Guide for replacing the Printed Circuit Board (PCB).
Recommends returning PCBs to McMurdo for calibration.
Details the spare parts available for the SART.
Lists technical parameters of the SART, including frequency, power, and dimensions.
Outlines the warranty period, exclusions, and how to make a claim.
Instructions for safely disconnecting the battery before disposal.
Guidelines for environmentally responsible disposal of the SART and its battery.
To Next Page
General
