Commercial in confidence
Page 19
mcmurdo
mcmurdomcmurdo
mcmurdo
5.3. Re-tune PCB
Although it is possible to perform alignment of the PCB in the field, this is not a recommended
procedure because it requires specialised test equipment and suitably qualified technicians.
It is strongly recommended that PCBs are returned to McMurdo for calibration.
5.4. Factory return procedure
If a SART cannot be repaired in the field, it should be returned to the factory.
The SART assessment form must be completed and returned with the SART to show the tests
which have been performed and the results obtained.
To Next Page
