EasyManuals Logo

McQuay WMC Service Manual

McQuay WMC
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #53 background imageLoading...
Page #53 background image
www.DaikinApplied.com 51 IOM 1210-1 • MAGNITUDE
®
MODEL WMC CHILLERS
operaTIon
Table 19 continued: Menu Matrix
NOTE: Screens listed in this table that have a gray background require a technician level password to manipulate.
VIEW
CONDENSER
ALARM
LOG
SET UNIT
SETPOINTS
SET COMPRESSOR SETPOINTS
SET ALARM
LIMITS
SET TOWER
SETPOINTS
SET
PASSWORD
VIEW CONDENSER
Disch SH = 000.0°F
Approach = 00.0 F
Subcooling= 00.0 F
Alarm Log: 01
description
HH:MM:SS
MM/DD/YY
SET UNIT SPs (1)
Unit Enable = Off
Unit Mode = Cool
Source = Switches
SET COMP SPs (1)
Demand Limit=Off
Minimum Amps=010%
MaximumAmps=100%
SET COMP#2 SPs (1)
Demand Limit=Off
Minimum Amps=010%
Maximum Amps=100%
SET ALARM LMTs (1)
LowEvPrHold=27psi
LowEvPrUnld=26psi
LowEvPrStop=25psi
SET TOWER SPs (1)
TowerControl=(type?)
Tower Stages=1
StageUP/Dn=080/020%
SET PASSWORD
Enter
Password:00000
No Access Given
Alarm Log: 02
description
HH:MM:SS
MM/DD/YY
SET UNIT SPs (2)
Available Modes
= Cool
Select w/Unit Off
SET COMP SPs (2)
StageMode =Normal
StageSequence# = 01
Max Compr On = 02
SET COMP#2 SPs (2)
StageMode =Normal
StageSequence# = 01
Max Compr On = 01
SET ALARM LMTs (2)
HighCondPr =140psi
HiDschT-Load=170°F
HiDschT-Stop=190°F”
SET TOWER SPs (2)
Stage ON
#1 #2 #3 #4
xxx xxx xxx xxx
SET PASSWORD (2)
Tech Password
00000 00000
No Access Given
Alarm Log: 03
description
HH:MM:SS
MM/DD/YY
SET UNIT SPs (3)
Cool LWT = 44.0°F
Ice LWT = 25.0°F
Heat LWT = 135.0°F
SET COMP SPs (3)
StageDeltaT = 1.0°F
Stop-Start = 03 min
Start-Start = 05 min
SET COMP#2 SPs (3)
StageDeltaT = 1.0°F
Stop-Start = 03 min
Start-Start = 05 min
SET ALARM LMTs (3)
WMC Compressor
Oilless Design
(blank mask page)
SET TOWER SPs(3)Fans
VFD Min Spd = 20.0%
StageDiff= (type? Psi/F)
Stg Up=02 Dn=05 min
^ I
I v
SET UNIT SPs (4)
Leaving Water Temp
StartDelta= 03.0°F
StopDelta = 3.0°F
SET COMP SPs (4)
UL Surg Ofs=200RPM
Name Plate RLA 140
SET COMP#2 SPs (4)
Name Plate RLA 140
SET ALARM LMTs (4)
Surge Slp Str=20°F
Surge Tmp Run=20°F
MtrCurThrshld=05%
SET TOWER SPs (4)
Valve/VFD Control=
None
Valve Type=NC
^ I
I v
SET UNIT SPs (5)
Rest Type = NONE
MaxResetDT =00.0°F
StrtResetDT = 10.0°F
SET COMP SPs (5)
Lead Staging = 030%
Nom Capacity=0100T
HG-Bypass=30% RLA
SET COMP#2 SPs (5)
Nom Capacity=0100T
HG-Bypass =30%
SET ALARM LMTs (5)
Evap Freeze= 34.0°F
Cond Freeze= 34.0°F
SET TOWER SPs (5)
Valve Sp= 065°F
Reset = 20.0psi
Sensor = ECWT-B3
^ I
I v
SET UNIT SPs (6)
Soft Load = OFF
InitialSLAmps= 020%
SoftLoadRamp=05min
SET COMP SPs (6)
IntrLokTmr=010sec
UnloadTimer=120sec
Max Str LWT=10.0°F
SET COMP#2 SPs (6)
Same as Comp #1
SET TOWER SPs (6)
ValveStartPosition
Min=010% @ 060°F
Max=100% @ 090°F”
Alarm Log: 25
description
HH:MM:SS
MM/DD/YY
SET UNIT SPs (7)
Max/Min LWT Rates
Max = 1.0°F/min
Min = 0.4°F/min
SET COMP SPs (7)
Vane Control
Lead Start = 012%
Lag Start = 040%
SET COMP#2 SPs (7)
WMC Automatic
Vane Control
(blank mask page)
SET TOWER SPs (7)
Valve Control Range
Min= 010% Max= 100%
Tower Loop = 1.7min
SET UNIT SPs (8)
EvapRecTmr = 0.5min
EvapPump = #1 ONLY
CondPump = #1 ONLY
SET COMP SPs (8)
Start Speed
Lead Str Spd = 015%
Lag Str Spd = 003%
SET COMP#2 SPs (8)
WMC Automatic
VFD Control
(blank mask page)
SET TOWER (8) ByP xxx%
FB +075.4 Intg Derv
Trg+075.0 006s 01g
Gain 20 D-Band01.0
SET UNIT SPs (9)
Templier Src Water
No Start = 070°F
Delta Reset = 055°F
SET COMP SPs (9)
Protocol=M-Bus MSTR
Id ent Number= 001
Baud Rate = 19200
SET COMP#2 SPs (9)
Starter Set Up
Same as Comp #1
SET TOWER (9) VFD xxx%
FB +075.4 Intg Derv
Trg+075.0 600s 001s
K08.0 Db0.0 Tc0500mS
SET UNIT SPs (10)
VFD = Yes
Harmonic Filter
Engages > 06 RLA%
SET COMP SPs (10)
Refrg Sat Pressure
Evp Offset =+00.0 psi
Cnd Offset =+00.0psi
SET COMP#2 SPs(10)
Refrg Sat Pressure
Evp Offset =+00.0 psi
Cnd Offset =+00.0psi
Db Tower R06.5 F0653
CAF*+013 +012 UT250
Spd 120 000% S0200
RLA-05 CsP+002 m1000
SET UNIT SPs (11)
Max Wtr Flow Rates
Evap WF=02400GPM
CondWF=03000GPM
SET COMP SPs (11)
ELWT Offset = +0.0 °F
Orbit Limit = A
SET COMP#2 SPs (11)
Uses Comp#1 Sensor
Orbit Limit = C
SET UNIT SPs (12)
Day Lt Saving Time
Day/Mon/Yr
24 hr time day of wk
SET UNIT SPs (13)
Refrigerant=R134a
Display=°F/psi(IP)
Lang = English
SET UNIT SPs (14)
Protocol = MODBUS
Id #= 001 Units =IP
Baud Rate = 19200
SET UNIT SPs (15)Exv
EXV Gain=078 Md078
Offset=0700 Md0700
Prs Ctrl DOut10.0°F

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the McQuay WMC and is the answer not in the manual?

McQuay WMC Specifications

General IconGeneral
BrandMcQuay
ModelWMC
CategoryChiller
LanguageEnglish

Related product manuals