MCS Master DH 752 - Water Leakage

shock.
► FIG. 12
Put the unit stably. If the unit turns over, the wa-
ter will ow out from the tank and damage the
objects nearby. Moreover, because of the dam-
age, it might result in re or an electric shock
► FIG. 13
Make the lter more endurable. When off for a
long time, seal the lter in a plastic bag.
► FIG. 14
Do not use the unit near water. The unit might
be damaged when soaked in water, so as to re-
sult in re or electric shock.
► FIG. 15
Use the standard electric source of
220-240V/~50Hz. Otherwise it might result in
re or electric shock.
► FIG. 16
Do not damage the wire. Do not put anything
heavy on the wire or heat or pull the wire. Oth-
erwise it might result in re of an electric shock.
► FIG. 17
Clean the dirt on the plug and x it tightly. If the
plug is not xed tightly, it might cause an electric
shock.
► FIG. 18
Do not regard the plug as a switch. Otherwise it
might result in re or an electric shock.
► 5. NOTICES ABOUT UNIT OPERA-
TION
► When moving the unit, do not tilt over 45°to
avoid any damaging of the compressor.
► The unit should be operated between 5°~32°.
► When dehumidifying, because of the heat re-
sulted from the running compressor, the indoor
temperature will rise by 1°~3°. Such a reaction
should be considered as normal.
► When indoor temperature is below 10°, and
the ambient absolute humidity is quite low, it is
unnecessary to use the machine.
► Air inlet and air outlet should be at least 10cm
away from the wall.
► Try to keep the room closed to enhance the
dehumidication effect.
► Too much dirt on the lter affects dehumidi-
cation, may even result in malfunctioning of it,
thus it should be cleaned at least once a month.
If there is a great amount of powder in the air,
the lter must be cleaned once a week, or even
every day. Pull the front panel out and clean the
lter. If necessary, you may slightly knock all
over the lter, use a vacuum cleaner to remove
bigger pieces of dirt or even wash the lter in
warm clean water (≤40% with some neutral de-
tergents) and then dry it.
► 6. TROUBLE-SHOOTING
UNIT DOES NOT WORK
► Analysis
1.Power cut
2.Switch off
3.Unplugged
4.Fuse melted
5.Tank full
► Solution
1.Power on
2.Switch on
3.Plug on
4.Exchange fuse
5.Empty the tank and replace it
DEHUMIDIFIES IN INADEQUATELY
► Analysis
1.Filter choked by dirt
2.Some barrier
in air inlet or outlet
3.Door or windows open
4.Refrigerant leakage
► Solution
1.Clean the lter
2.Remove the barrier
3.Close the door and windows and
seclude from the sunshine
4.Contact the manufacturer or seller
WATER LEAKAGE
► Analysis
1.The unit is inclined
2.Drainer choked
en
it
de
es
fr
nl
da

no
sv
pl
ru
cs
hu
sl
hr
lt
lv
et
ro
sk
bg
uk
zh
SI
SK