PC Software installation and report
Installation
Attach the memory device supplied, to your PC USB port. When prompted,
open the folder and execute the setup.exe file. This will guide you through
the installation process. This will load the required software and drivers to
communicate with the device. It will also add an icon on your desktop.
Modes of operation when connected to the PC
The RP Check can be used in two modes:
1. USB connection to the PC to upload the last patients tests that have
been stored on the unit
2. “Live tests” performed on the RP Check and the results will be
displayed on the PC software as well as on the unit.
For both of the above modes of operation, turn the RP Check ON and
connect the USB cable to the side of the unit and to a free USB port on the
PC.
Note: When the RP Check is connected to the PC via the USB cable it will
gain power from the USB port and will not use the battery. To turn the unit
OFF disconnect the USB and press the ON/OFF button of the keypad until
the unit turns OFF.
Uploading a patient’s tests to the RP Check software from the unit:
a) Connect the USB cable to a free port of the PC and to the USB port
of the PC
b) Turn the RP Check unit ON using the keypad
c) Double click on the RP Check desktop icon
d) Click on the Connect button of the RP Check software and the
patient demographics fields will be displayed
To Next Page
Loading...