36
the MDC Polyblock hitch is an easy to use off-road
coupling. Requiring little maintenance and being very
reliable had made it popular with users everywhere.
Just a few simple steps and you’ll be hitched up and
towing in no time.
1. Reverse the vehicle to the hitch and adjust the
camper jockey wheels to the correct height.
2. Slide the polyblock into the receiver and line up
the holes for the pin
3. Insert T pin through centre of the hitch receiver
and polyblock
4. Insert R clip through bottom of T pin
5. Connect safety chains and electrics
6. Wind up and store the jockey wheel
Note: Your MDC camper is fitted with electric brakes so
always have a shaft toggle set down on the shaft as
pictured. This feature is only used for “override” brakes.
If you are travelling off-road it’s a good idea to secure
the R clip with some ties to prevent it from being
pushed out should you drag your towbar through dirt or
mud.
Maintenance:
Regularly grease the two grease nipples on the hitch to
ensure the hitch articulates well. Also lightly grease the
T pin and spray the polyblock with some silicone spray
to stop squeaking.
USING THE POLYBLOCK HITCH
Line up the coupling and insert T pin
Always have the reversing toggle closed as pictured
Insert R clip through the bottom of the pin
To Next Page
Loading...