MDC Robson XTT 2015 User Manual (English)

Questions and Answers:

B
Brent AlvarezAug 7, 2025
What to do if water drips from the P&T safety valve in my MDC Robson XTT 2015 Utility Vehicle?
- T
  Timothy MitchellAug 7, 2025
  If water drips from the P&T safety valve, it could be due to high water pressure or dirt under the valve seat. First, check the water pressure and ensure it doesn't exceed 400 kPa; use a pressure reducer if connected to a central water supply. Then, allow the appliance to cool, slowly raise the test lever to flush the water system, and try to remove any dirt from the P&T safety valve seat. If the issue persists, a certified service technician should replace the P&T safety valve.
S
Steven HillAug 14, 2025
Why does my MDC Robson XTT 2015 Utility Vehicle heater operate for a long time and then the red lamp lights up?
- J
  Jill Burns MDAug 14, 2025
  If the heater operates for a prolonged time and then the red lamp lights up, it indicates that the excess temperature thermostat has activated. Check the water level and refill if necessary, ensuring you close the drain valve. To unlock the system, switch off the appliance, wait 5 minutes, and then switch it on again.
V
vlawsonAug 21, 2025
What to do if my MDC Utility Vehicle heater does not operate when switching on, and the red lamp lights up after about 30 seconds?

General