MDS 05-2806A01, Rev. F iNET Series User’s Guide 73
3.6.8 Point-to-Multipoint Serial-to-Serial Application
Example
The operation and data flow for this mode is very similar to
Point-to-Point serial-to-serial application, except that it uses multicast
addressing. The primary difference is that data presented at the Access
Point’s
COM port will be packetized and sent via UDP to all of the
Remotes. Upon receiving the packet all of the Remotes strip the data out
of the UDP packet and send it out their
COM port. Likewise, data pre-
sented at any of the Remotes’
COM ports is packetized, sent to the
Access Point, stripped, and sent out the Access Point’s
COM port (see
Figure 3-34, Table 3-3, Figure 3-35, and Figure 3-36 on Page 75.
SIFD 4
IP Protocol UDP
Remote IP
Address
192.168.0.2
(IP address of the Remote radio)
Remote IP Port 30011
Local IP Port 30011
Remote Unit (COM2)
1
Status Enabled
Data Baud Rate 9,600 (Example)
Flow Control X-ON/X-OFF (Example)
Serial Mode Seamless
SIFD 4 (Characters)
IP Protocol UDP
Remote IP
Address
192.168.0.1
(IP address of the AP)
Remote IP Port 30011
Local IP Port 30011
1. Either COM port can be used, but they must be the same ones at both ends
of the link. Both COM ports can be used simultaneously for two independent
data channels.
Table 3-2. Serial Port Application Configuration (Continued)
Transceiver Location Menu Item Setting
To Next Page
