MDS TransNET 900 - Page 93

MDS 05-2708A01, Rev. D MDS TransNET I&O Guide ix
Temperature, display internal (TEMP command) 43
Terrain 7
Terrain and Signal Strength 7
Test, on-the-air 7
Transceiver
connecting to data equipment 15, 22
default settings 34
mounting instructions/dimensions 14–15
performance optimization 20
sleep mode 59
Transceiver Sleep (SLEEP) 42
Troubleshooting 45–48
performing network-wide diagnostics 49
table 48
Turn Off Radio Transmitter Test Signal (DKEY) Command 33
Turn On Radio Transmitter Test Signal (KEY) Command 35
U
UNIT Command (unit address) 43
Upstream Repeat Transmission Count Command (RETRY) 38
X
XADDR (extended address command) 17, 27, 34, 35, 45, 55, 58
XADDR (extended address) Command 37
XPRI command (display/set extended address) 44
XRSSI command (sets minimum RSSI level to maintain sync. w/non-primary
extension radio) 44
Z
ZONE CLEAR (clear zone statistics log) 44
ZONE DATA Command (read zone statistics log) 44
Zone, Clear Statistics Log (ZONE CLEAR) 44
Zone, Read Statistics Log (ZONE DATA) 44