MECANIL SG280 A G2 - User Manual

MECANIL SG220 / SG280
Manual
Mecanil Products
All rights reserved. Specifications are subject to alteration.
Mecanil Oy Ab can not be held responsible for possible type errors or inconsistencies in this spare parts list.
GENERATION 2

Summary

Safety instructions

General safety instructions

Outlines essential safety precautions to be followed while operating the grapple saw.

Instructions for safe operation

Description of labels; Warning labels

Labels and warning symbols on the grapple

Installation

Basic installation instructions

Take in use - handheld remote (RC-T)

Controlling the grapple saw by remote safely

Take in use - remote with push buttons (RC-M) with or without collecting unit

Charging the battery

Controlling the grapple saw by separate push buttons

Take in use - cable control with push buttons, with or without collecting unit (A)

Control with the cranes own remote

Chart for Scanreco P2 remote control

Connections under the main connector

Switches, digital on;off

SG220 or SG280 with wireless control

RC-M versions

For connection to integrate into cranes remote

Shows how to connect the grapple saw's wireless system to a crane's remote.

Use and Maintenance

Initial check before use

Lists essential checks to perform before starting to use the grapple saw.

Check after first use

Daily use and maintenance

Service

Outlines the importance and procedure for regular service and maintenance.

Chain lubrication

Explains how and where to perform chain lubrication.

Tensioning the drive belt

Check tension of the belt after tensioning or replacement

Tensioning the saw chain

Replacing saw bar and saw chain

Taking saw bar and chain off

Step-by-step instructions for removing the saw bar and chain.

Install new saw bar and saw chain

Adjusting the speed of the saw bar

Lubrication points

Hydraulics

Valve set

Hydraulic schematic

Electronics

Electronics schematic

Technical data

SG220

Lists technical specifications for the SG220 model variants.

SG280

Lists technical specifications for the SG280 model variants.

Technical data - wireless control

Transmitter - 3 buttons

Transmitter - separate pushbuttons

Instructions for pairing transmitter to receiver

Warranty conditions

Form - Warranty application

MECANIL SG280 A G2 Specifications

General

Category	Saw
Model	SG280 A G2
Blade Diameter	280 mm
Voltage	230 V
Frequency	50 Hz
Motor Power	2000 W