Mecc Alte SMARTECH GC315 - Digital Outputs

GC315-Remote User Manual
Code: EAAM075101EN
Rev. 01 | Date: 14/10/2022
Controller
GC315 – Remote
ENGLISH
Mecc Alte S.p.A. - Full or partial reproduction prohibited, if not authorized
8
See the technical manual of GC315 for the electrical characteristics of the inputs and for the wiring
recommendations.
All inputs are configurable as function (parameter P.2001 and equivalent), as delay (P.2002 and
equivalent) and as polarity (P.2000).
The available functions are:
Function
Description
Activation
Delay
Deactivation
Delay
0000
Not used
-
.
2032
Request for REMOTE START mode
Yes
Yes
2033
Manual START command
Yes
.
2034
Manual STOP command
Yes
.
4201
Emergency stop
Yes
.
The last two columns indicate whether the controller uses or not the configured delay at the
activation/deactivation of the input. Remote sends the commands acquired by the digital inputs to
GC315 using the communication line (RS232, RS485 or ETHERNET).
The default configuration is:
Input
Function
1
4201
2
2032
3
2033
4
2034
4.3 Digital outputs
Remote provides eight digital outputs:
• For static transistor outputs. When activated, they provide the positive power supply voltage
of the controller (maximum 500 mA total consumption) on output terminals. They are
available on JE connector:
1. Output 1.
2. Output 2.
3. Output 3.
4. Output 4.
• Two digital outputs (relay 3 Ampere @ 30 Vdc). When activated, they provide the positive a
positive voltage on terminals. They are available on JL connector:
1. Positive common voltage.
2. Normally open terminal for output 5.
3. Normally open terminal for output 6.
• two digital outputs (relay 10 Ampere @ 250 Vac). The JI connector provides the dry contacts
for the relays:
1. Normally open terminal for output 7.