5
www. mechmaxx.com
MACHINE USE AND CARE
SERVICE
PROPOSE
SAFETY
Loose the fuel tank cap slowly to relieve any pressure in
the tank.
Never over fill fuel tank. Fill tank to no more than 12.5
mm(1/2") below the bottom of the filler neck to provide
space for expansion as the heat of the engine can cause
fuel to expand,
Replace all fuel tank and container caps securely and
wipe up spilled fuel, Never operate the unit without the
fuel cap securely in place.
Avoid creating a source of ignition for spilled fuel. If fuel is
spilled, do not attempt to start the engine but move the
machine away from the area of spillage and avoid creating
any source of ignition until fuel vapors have dissipated.
Store fuel in containers specifically designed and
approved for this purpose.
Store fuel in a cool. well-ventilated area, safely away from
sparks, open flames or other sources of ignition.
Never store fuel or machine with fuel in the tank inside a
building where fumes may reach a spark, open flame, or
other sources of ignition, such as a water heater, furnace,
clothes dryer and the like, Allow the engine to cool before
storing in any enclosure.
Position the machine in such a way that it can not move
during maintenance, cleaning, adjustment, assembly of
accessories or spare parts, as well as under storage,
Do not force the machine. Use the correct machine for
your application, The correct machine will do the job
better and safer at the rate for which it was designed.
Do not change the engine governor settings or over-speed
the engine. The governor controls the maximum safe
operating speed of the engine.
Do not run the engine at a high speed when you are not
working.
Do not put hands or feet near rotating parts.
Avoid contact with hot fuel. oil. exhaust fumes and hot
surfaces.
Do not touch the engine or muffler. These parts get
extremely hot from operation. They remain hot for a short
time after you turn off the unit, Allow the engine to cool
before doing maintenance or making adjustments.
If the machine should start to make an unusual noise or
vibration, immediately shut off the engine, disconnect the
spark plug wire, and check for the cause, Unusual noise or
vibration is generally warning of trouble .
Use only attachments and accessories approved by the
manufacturer. Failure to do so can result in personal
injury.
Maintain the machine. Check for misalignment or binding
of moving parts. breakage of parts and any other condition
that may affect the machine's operation. If damaged.
have the machine repaired before use. Many accidents are
caused by poorly maintained equipment.
Keep the engine and muffler free of grass,leaves, exces-
sive grease or carbon build up to reduce the chance of a
fire hazard.
Never douse or squirt the unit with water or any other
liquid. Keep handles dry, clean and free from debris. Clean
after each use.
Observe proper disposal laws and regulations for gas.oil
etc,to protect the environment.
Store idle machine out of the reach of children and do not
allow persons unfamiliar with the machine or these
instructions to operate it. Machine is dangerous in the
hands of untrained users.
Before cleaning, repair, inspecting, or adjusting, shut off
the engine and make certain all moving parts have
stopped. Disconnect the spark plug wire, and keep the
wire away from the plug to prevent accidental starting.
Have your machine serviced by qualified repair personnel
using only identical replacement parts This will that the
safety of the machine maintained.
Before using the Trencher:
Operators must be fully trained before using this machine.
User Manual is read and understood.
This machine is designed solely to dig
trench and must not be used for any other
purpose. It should only be used by trained
operators who are familiar with the
content of this manual. It is potentially
hazardous to fit or use any parts other
than your dealer parts. We disclaim all
liability for the consequences of such use,
which in addition voids the machine
warranty
To Next Page
