EasyManua.ls Logo

medi Circaid Juxtafit Essentials - Application and Removal Instructions; Donning and Doffing Lower Leg Garment

medi Circaid Juxtafit Essentials
86 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
English
English
circaid juxtafit essentials knee cover
53% Polyurethane
41% Nylon
4% Elastane
2% Polyethylene
This garment does not contain latex.
Washing instructions
The garment can be machine washed
using a gentle cycle and dried on a low
heat setting.
To extend the life of the garment, hand
wash and drip dry.
Machine wash warm
Do not bleach
Tumble dry, low heat
Do not iron
Do not dry clean
Do not wring
Wearing recommendation
Always ensure that the correct
prescribed pressure range is being
applied.
Slightly loosen the bands of the garment
for night-time wear.
Each vertical BPS line on the bands may
be at a different location on the leg
depending on the size and shape of the
leg. They do not need to be aligned down
the front center of the leg or in any other
specific location on the leg.
If experiencing any pain, immediately
remove the garment.
When bands are placed correctly they
should slightly overlap, leaving no space
between bands.
Do not tuck bands. The Velcro tabs
should never touch the skin!
Donning the circaid® juxtafit®
essentials lower leg
Step 1: Slide the circaid undersleeve onto
the lower leg and over the knee. The
cuffed edge of the undersleeve should
cover the heel. Ensure that there are no
wrinkles in the undersleeve.
Step 2: Align the garment just above the
ankle bone and below the knee crease.
The black side of the material should
face the skin. Unroll the top two bands
and loosely secure them to the outside
of the garment to anchor the legging in
place. This enables you to easily raise or
lower the garment for correct
positioning.
Note:
The bottom most band can be identified
by the circaid-logo on the black side of
the material.
Step 3: Unroll the bottom two bands and
secure the bottom most band to the
outside of the legging to a firm and
comfortable compression level.
Step 4: While holding the second band,
detach the next band. Secure the second
band and continue this process with the
other bands, going up the leg.
Step 5: The garment should lay flat and
wrinkle free against the leg. Adjust each
band to a firm and comfortable
compression level. Ensure that the
bands are placed in an alternating order.
Step 6: Once all bands are secured,
inspect the garment for any gaps or
creases. Adjust the bands as necessary.
The legging should never hurt. If any
pain is being experienced, the legging
E012040_GA_Circaid_juxtafit_essentials.indd 3 07.09.17 11:32

Related product manuals