To Next PageTo Next PageWhy is there no ECG waveform display on my Mediana M20 Monitor?
If there's no display on the ECG waveform menu of your Mediana Monitor, even though the ECG accessories are connected to the patient, check the ECG accessories and electrode connection. Re-position ECG cables and replace accessories and electrodes if necessary. If the problem persists, the ECG module or the Main Board may be broken and require replacement.
What causes rapid and erratic detections on my Mediana M20 Monitor?
Rapid, large, and erratic detections on your Mediana Monitor can be caused by a broken wire in the patient lead or a poorly applied sensor. Replace the wire and electrode. If the problem continues, the ECG module or the Main board may be broken and require replacement.
Why is there no sound during POST on my Mediana Monitor?
If there's no sound during the POST on your Mediana Monitor, the speaker might be broken, or the speaker wire could be loose or disconnected. Reconnect the wire or replace the speaker. If the issue persists, the Main Board might be malfunctioning and need replacement.
Why is the respiration value inaccurate on my Mediana Monitor?
If the respiration value is inaccurate on your Mediana Monitor, the gain might be too low; select an appropriate gain from the Respiration menu. Also, check that the electrodes are attached tightly.
What to do if the alarm on my Mediana M20 Monitor cannot be silenced?
If the alarm on your Mediana Monitor cannot be silenced, the key assembly board or the Main Board might be broken and need replacement.
General safety guidelines for the M20 monitor.
Alerts to potential serious outcomes for patient or user.
Identifies conditions causing damage to equipment or property.
Lists parameters monitored and contraindications.
Identifies and describes components on all monitor panels.
Procedures for surface cleaning of the monitor and accessories.
Annual checks for safety and proper functionality.
Guidelines for battery care, charging, and replacement.
Overview of tests for verifying performance after repairs or during maintenance.
Lists necessary equipment for performance verification tests.
Procedures for testing monitor functions like power, battery, and POST.
Tests alarm functionality and temporary silencing of audio alerts.
Procedure to adjust and verify audible beep volume for pulse rate.
Verifies the functionality of the SpO2 sensor's LED intensity control.
Verifies alarm limits and settings revert to factory defaults.
Tests to verify ECG monitoring, lead detection, and waveform display.
Tests to verify the functionality of the NIBP pneumatic system.
Tests to verify SpO2 and pulse rate measurements.
Checks the integrity of the monitor's grounding wire.
Tests for earth, enclosure, and patient leakage currents.
Measures leakage current from patient connections to earth.
Measures auxiliary current between different patient connections.
Procedures for configuring monitor settings and power-on defaults.
Lists default parameter settings for different patient modes.
Step-by-step instructions for downloading firmware via USB or TCP/IP.
Information to assist in troubleshooting the M20 monitor.
Categorized list of common problems and their symptoms.
Lists error codes and conditions causing technical alarms.
Describes disassembly procedures and required tools.
Steps to replace the monitor's battery pack.
Procedures for separating the front and rear case assemblies.
Steps for removing the main logic board.
Technical specifications for the monitor's display.
Physical dimensions, weight, and printer specs.
Specifications for power requirements, fuses, and battery.
Describes the characteristics of various alarm and notification tones.
Detailed measurement parameters for Electrocardiography.
Detailed measurement parameters for Non-Invasive Blood Pressure.
Detailed measurement parameters for oxygen saturation.
Detailed measurement parameters for temperature monitoring.
General description of the M20 monitor's functions and operation.
Visual representation of the monitor's internal system architecture.
Description of the monitor's main functional units.
Explains how ECG signals are acquired and processed.
General