4
OPERATING INSTRUCTIONS
1. Plug in the electronic stepper.
2. Press the Power button to turn on the power.
Power: The device is now ready to be operated.
FUNCTION:
Auto Exercise:
Auto Exercise: Press the Mode button once to activate P1,
twice to activate P2, and three times to activate P3.
The pedals will rotate at a different speed and direction when set to these
different Auto Modes.
Note: Speed and Direction CANNOT be adjusted on Auto Mode.
Manual Exercise (HR): Press the Power button until the letters HR are
displayed on the screen. The device is now set to Manual Mode.
There are 5 Speed levels, each is outlined below:
01: 0.58KM/H
02: 0.93KM/H
03: 1.28KM/H
04: 1.64KM/H
05: 2.11KM/H
Direction: Press this button to switch the pedaling direction. Only available
on HR (Manual Exercise).
Speed: Press this button to increase or reduce speed among the 5 Speed
levels: 01, 02, 03, 04, 05. Only available on HR (Manual Exercise).
Mode: Press this button to alternate the information displayed on the screen
for: Scan, Time, Distance, Speed, Counter, and Calorie
Note:
1. After the device stops operating a function mode:
Panel: Press the Power button to start/stop the function.
Remote: Press the Start/Stop button to start/stop the function.
2. When the device is operating and your Function has been selected, it will
take the device 3 seconds to start.
To Next Page
Loading...