Concentration
The silver concentration is given in parts per million, abbreviated “ppm”.
ppm = ratio to determine the molecular presence of a particular substance (e.g. silver) per million
parts in relation to another one (e.g. water)
In conventional devices, the production time depends on temperature, conductivity, quality of the
used water, and the surface of the electrodes. The silver concentration is not regular and can
achieve the multiple value in only twice the time of production. Stirring during production also
changes the concentration.
The Ionic-Pulser compensates these factors. The silver concentration is the same for each type of
water and proportional to the time of production, that is to say, doubled time = twice the
concentration.
Concentrations (ppm) can be determined according to the table.*
Choose the amount of water in the horizontal line (size of the production container), in the vertical
line below the desired ppm value, and read on the left side, on the same level, the production time.
Table for Ionic-Pulser PRO: Table for Ionic-Pulser STANDARD S:
* When using bi-distilled water, the production time has to be extended for 3 minutes.
Do not heat the silver dispersion during and after the preparation process!
Only stir after 15 minutes!
At low concentrations colloidal silver is colourless and tasteless. At higher values a discolouration
occurs. This discolouration may vary extensively at the same concentration. The higher the
concentration the more intense the bitter metallic taste, regardless of the colour or the quality of the
silver solution.
To Next Page
Loading...