Need help?Do you have a question about the Medivance Arctic Sun Stat and is the answer not in the manual?
Provides a general overview of the Arctic Sun temperature management system.
Details the intended patient population and use cases for the system.
Critical safety information and precautions for system operation.
Steps for safely opening the device packaging.
Instructions for connecting cables and power.
Procedure to start the Arctic Sun system.
Navigating the system to select patient therapy modes.
Choosing the correct ArcticGel pad type for therapy.
Description of displays and functions on therapy screens.
Steps to confirm proper system operation after initial setup.
Description of the system's fluid-handling parts.
Description of the system's electrical and control components.
Explanation of the primary fluid pathways within the system.
Explanation of secondary fluid pathways like filling and draining.
Overview of how the system's electronics manage operation.
Recommended intervals for routine system maintenance.
Procedure for cleaning and disinfecting the device exterior.
Steps for cleaning the device using germicidal wipes.
Post-cleaning checks to ensure device readiness.
Checking the integrity of system connectors and cables.
Procedure for cleaning the chiller condenser.
General visual inspection of the device for damage.
Instructions for refilling the internal cleaning solution.
Understanding the interface and options in Advanced Setup.
Key features and capabilities accessible via Advanced Setup.
Configuring the device's location and time parameters.
Viewing system information like software version.
Description of the specific data parameters available for download.
Critical alarms that halt system operation until addressed.
Alarms requiring timely operator intervention for patient safety.
Alarms indicating conditions that may need attention.
Alarms that permanently stop therapy if not resolved.
Alarms that temporarily stop the system, clearing upon correction.
Accessing and interpreting system diagnostic data for troubleshooting.
Viewing recorded system alarms and events for troubleshooting.
General methods and best practices for diagnosing and resolving issues.
List of tools and supplies needed for component replacement.
Procedure for draining the system before disassembly.
Steps for removing the rear panel of the control module.
Steps to replace components within the front case assembly.
Instructions for safely removing and replacing internal circuit cards.
Procedure for replacing the isolation circuit card.
Procedure for replacing the processor circuit card.
Procedure for replacing the power circuit card.
Procedure for replacing the connector panel bracket assembly.
Procedure for replacing the fluid level sensor.
Procedure for replacing the inlet/outlet manifold.
Procedure for replacing the power supply unit.
Steps to access internal components by removing upper parts.
Procedure for replacing the circulation pump.
Steps for removing internal components from the chiller frame.
Description of the Calibration Test Unit (CTU) for system calibration.
Guidelines on when to perform calibration or checks.
Steps required to prepare the system for calibration.
Detailed instructions for executing a system calibration.
General| Brand | Medivance |
|---|---|
| Model | Arctic Sun Stat |
| Category | Medical Equipment |
| Language | English |
To Next Page
