8. CLEANING INSTRUCTIONS
Clean Collection Bottle:
1. Turn off the suction unit and allow vacuum to drop, then disconnect AC power source.
2. With the collection bottle still in the holder, remove the collection bottle lid. The bottle
can now be taken out of the holder to be emptied.
NOTE
Collection bottle should be emptied after each use.
3. Collection bottle should be thoroughly cleaned after each use by one of the following
three methods:
a. Wash in a hot water/dishwashing detergent solution and rinse with clean, hot tap
water. Then wash in one part vinegar to three parts hot water solution. Rinse with
hot tap water and air dry.
b. Wash with rubbing alcohol and air dry
c. Wash with a commercial (bacterial-germicidal) disinfectant, follow disinfectant
manufacturer's recommended instructions and dilution rates carefully.
Collection Bottle Lid
Holder
Collection Bottle
To Next Page
Loading...
Need help?
General
