19
GENERAL USE INSTRUCTIONS
To Swing-away / Remove the Legrest assembly:
1. Fold the footplate up to the vertical position.
2. Release the legrest lock by pushing on the legrest lever.
3. Swing the legrest outward and to the side.
4. To remove the legrest, lift up on the assembly to remove the legrest off the
hinge pins.
SAFETY INSPECTION & MAINTENANCE
It is highly recommended that the transport wheelchair be taken to a qualified
dealer annually for a thorough inspection and maintenance / repair service.
GENERAL CARE
• Wipe off chrome / aluminum parts at least once per week using a clean, soft cloth.
• Clean all metal parts with auto wax or similar products.
• Dry the chair immediately if exposed to moisture.
• Do not use abrasive cleanser or materials that will scratch the finish of the chair.
• Clean the upholstery with a mild soap solution, rinse and wipe dry.
• Clean the hand grips with water only and dry thoroughly. Use of soap or
ammonia based cleaning solutions may loosen the grips.
MONTHLY CHECK LIST / TROUBLESHOOTING
General:
Inspect the entire wheelchair for broken parts, sharp edges and loose fasteners.
Ensure that everything works and the chair rolls straight without drag and does not
pull to one side. Replace or tighten parts as needed. Inspect for bent frame and
crossbars.
Frame and Crossbraces:
Check that the frame and crossbraces are not bent or dented. Check the tubing for cracks
and rust. If such issues are found, take the wheelchair to your local service dealer.
To Next Page
Loading...
Need help?
General
