10 MEDLINE | MDS86835DSHEC | PIC-00311 (Rev: 10-20-16)
Backrest Assembly
1. Insert backrest into designated slot so that push-buttons are facing outward
(see Figure A).
2. Push buttons in and continue to insert backrest until buttons securely lock into
holes (see Figure B). Please note: There are 2 positions for the back rest. Adjust
according to your preference, but make sure both push buttons are protruding
and at the same level (see Figure C).
Notes: Make sure the brakes are locked before you lean against backrest.
Make sure push-buttons are completely protruding before leaning
against backrest.
Figure A
Figure B
Figure C
To Next Page