Charging the meter
The Bayer meter has a permanent rechargeable battery. Before use, the meter needs to be fully charged.
To charge the meter:
1) Remove the cap with on it to reveal the USB connector.
2) Plug the USB connector into a computer. The computer must be ON and not in sleep, hibernate or power
save mode.
3) The meter will briefly display Do Not Test-charging and the test strip port light will flash. You cannot do a
blood glucose test while the battery is charging.
4) When charging is complete, the test strip port light will turn off. You can then unplug your meter.
The meter will need to charge for 3 hours out of the box and 2 hours to charge thereafter. A full
charge lasts approximately 2 weeks with the send function on.
Rapid Charge Feature: The meter can rapid charge. After 1 minute of charging, you can unplug the meter
and run one blood sugar test, if needed.
To Next Page
Loading...
Need help?
General