Need help?Do you have a question about the Medtronic guardian and is the answer not in the manual?
General| Type | Continuous Glucose Monitoring (CGM) System |
|---|---|
| Sensor Life | 7 days |
| Manufacturer | Medtronic |
| Sample Type | Interstitial fluid |
| Warm-up Period | 2 hours |
| Connectivity | Bluetooth |
| Transmitter lifespan | 12 months |
| Measurement Range | 40 to 400 mg/dL |
| Calibration | Required (fingerstick calibration) |
Lists general risks associated with using the Guardian Sensor.
Specifies the intended use of the Guardian Sensor with the Medtronic MiniMed system.
Details any conditions where the sensor should not be used.
Provides contact details for help and the official website.
Highlights important safety warnings and precautions for sensor use.
Instructions on how to manage bleeding at the sensor insertion site.
General safety measures to follow before and during sensor insertion.
Guidance on selecting appropriate body areas for sensor insertion.
Procedure for safely removing the sensor from the body.
Recommendations for storing and handling sensors to maintain integrity.
Information on the duration the sensor can be used.
Identifies the one-press serter and the glucose sensor assembly.
Identifies the sensor base and the transmitter.
Identifies the tape and other sensor-related components.
Covers washing hands, choosing, and cleaning the insertion site.
Procedure for opening the sensor package before insertion.
Instruction for removing the sensor assembly from its package.
Ensuring the adhesive tab is correctly tucked under the sensor connector.
Demonstrates the correct way to hold the serter for insertion.
Instructions for gripping the serter and pushing it onto the pedestal.
Procedure for detaching the serter from the pedestal after activation.
Guides on steady serter placement and pressing the buttons for insertion.
Instructions for holding the serter for adhesion and lifting it away.
Steps for a patient to remove the serter from the sensor.
Steps for a healthcare professional to remove the serter.
Instructions for applying the sensor's adhesive pad to the skin.
Procedure for untucking the adhesive tab from the sensor connector.
Instruction to straighten the sensor adhesive tab for flat skin contact.
Removing the initial liners from the oval tape.
Applying the oval tape to the sensor base and pressing firmly.
Connecting the transmitter to the sensor after initial tape application.
Steps for smoothing tape, covering the transmitter, and preparing second tape.
Applying the second piece of oval tape in the opposite direction.
Removing the final liners from the second piece of oval tape.
Smoothing the second piece of oval tape for secure adhesion.
Refers to other user guides for entering sensor settings into the pump or monitor.
Provides explanations for various symbols and icons used in the manual.
To Next Page
