BLUETOOTH PAIRING
Your headset must be paired to a Bluetooth device before it can be used. It is only necessary to pair
your headset once with each device.
1. Make sure the M9B is turned off and within 3 feet (1 meter) of the device you wish to pair. Press
and hold the Multifunction button for about 4 seconds until the headset says “Pairing”. The status
indicator light will flash red and blue in an alternating pattern while the M9B is in pairing mode.
Note: The M9B will remain in pairing mode for 5 minutes or until paired.
2. Open the Bluetooth menu on the device you wish to pair.
iPhone, iPad, and iPod touch
A) On your device, open the Settings menu
B) Select Bluetooth. If Bluetooth is not on, turn it on.
The iPhone/iPad/iPod® will automatically search for new devices
Android™ Phones and Tablets
A) On your device, open the Settings menu
B) Select Bluetooth (on older Android devices Bluetooth is found in the Wireless & Networks
menu). If Bluetooth is not on, turn it on. Select “Search for Devices” or “Refresh” if your phone or
tablet does not automatically search for new devices.
Windows® Phone 8 devices
A) On your device, open the Settings menu
B) Select Bluetooth. If Bluetooth is not on, turn it on.
Windows Phone 8 will automatically search for new devices Computers, Laptops, and Other
Devices
Visit www.MEEaudio.com/Bluetooth for pairing and setup information.
3. Wait until you see “M9B” on the screen of your device.
Select “M9B” on your device and follow any further prompts to pair. Use “0000” if a pin is
required. Once connected, the headset will say “Connected” and the blue indicator light will flash
three times every 9 seconds.
4. If pairing fails after several tries, please refer to your device’s user manual for additional
information. Visit www.MEEaudio.com/Bluetooth for instructional pairing videos and
troubleshooting information.
CONNECTING TO PAIRED DEVICES
When turned on, the M9B will automatically connect with the last paired and/or connected Bluetooth
device that is powered on and within range. If the headset does not connect automatically, open the
Bluetooth menu on your device and select “M9B” from the list of paired devices.
MULTIPOINT
Multipoint allows two Bluetooth devices to be connected to the M9B simultaneously. Both devices will
need to be paired before multipoint can be used by following the pairing procedure described in the
Bluetooth Pairing section for each device.
To use two Bluetooth devices with the M9B, turn the unit on and wait until it connects to the last
paired device. Then, select “M9B” from the Bluetooth menu of the second device you wish to connect.
The headset cannot be connected with more than two devices.
To switch between the two devices, pause audio playback on the active device and start audio
playback on the other connected device. It takes several seconds for the audio to switch.
Incoming calls will always take precedence over media. When a call comes in, the M9B will
automatically activate the device with the incoming call. Some devices, such as computers and
standalone audio transmitters, do not allow audio switching except when a phone call occurs.
If you no longer wish to connect to multiple devices, disable Bluetooth on the device you do not want
connected to the M9B or remove the “M9B” pairing from the Bluetooth menu of that device.
FUNCTIONALITY & CONTROLS
To Next Page
Loading...
