* You may need to bring your media player up on the screen for initial playback to start
** Not all devices/applications support this functionality.
FACTORY RESET
A factory reset will clear all paired devices from memory. To perform a factory reset, put the headset
in pairing mode as described in the Bluetooth Pairing section, then press and hold the Volume up and
Volume down buttons at the same time for 2 seconds. The headset will produce three tones and the
blue indicator light will flash twice to indicate the memory has been cleared. The headset will need to
be paired with a Bluetooth device before use.
SAFETY AND CARE
To clean, remove the eartips and rinse them under running water. Clean the earphones using a
cotton swab damp with a small amount of rubbing alcohol. Allow the earphones and eartips to dry
completely before resuming use.
Use only the supplied Micro-USB charging cable or a compatible replacement from a reputable
manufacturer.
Battery performance will be severely decreased when stored in extreme temperatures: below -
10°C/14°F or above 50°C/122°F, including direct sunlight.
If the device comes in contact with liquids, quickly wipe away. If submerged in water, do not turn
the device on until completely dried. Note: liquid submersion voids the warranty.
Do not use around flammable gasses as fire may occur.
Keep the device and packaging out of reach of children.
To Next Page
Loading...
