Select “MEE audio H6” and allow pairing to complete. Use
“0000” if a pin is required.
Note: It is only necessary to pair your headset once with
each device.
Multipoint Functionality
Multipoint allows two Bluetooth devices to be connected to
the headset simultaneously.
To use two Bluetooth devices with the H6D, first pair each
one by following the pairing procedure described in the
Pairing section, then power the headset off.
When powered on again, the headset will be able to connect
to both devices. If one of the devices does not connect
automatically, select “MEE audio H6” from the Bluetooth
menu of the device.
To switch between the two connected devices, pause audio
playback on the active device and start audio playback on
the other connected device. It may take up to 30 seconds for
the audio to switch.
Incoming calls will always take precedence over media. The
H6D will automatically activate the connected device that
has an incoming call.
To Next Page
Loading...
