Meec tools 009533 - Technical Data and Usage; Product Specifications; Product Components and Use

EN
32
TECHNICAL DATA
Rated voltage 18 VDC
Battery 2 Ah Li-Ion
Charging time Approx. 4 h
Speed 10000 rpm
Cutting width 230 mm
Trimmer line Ø 1.2 mm
Sound pressure level, LpA 72.40 dB(A), K=3 dB
Sound power level, LwA 87.37 dB(A), K=3 dB
Vibration 1.454 m/s², K=1.5 m/s²
Weight 2.2 kg
Always wear ear protection.
The declared vibration value, which has been
measured by a standardised test method, can be
used to compare dierent tools with each other
and for a preliminary assessment of exposure.
WARNING!
The actual vibration level when using power
tools may dier from the specied maximum
value, depending on how the tool is used. It is
therefore necessary to determine which safety
precautions are required to protect the user,
based on an estimate of exposure in actual
operating conditions (taking into account all
stages of the work cycle, e.g. the time when
the tool is switched o and when it is idling, in
addition to the start-up time).
DESCRIPTION
1. Main handle
2. Battery
3. Power switch
4. Telescopic lock
5. Trimmer guard
6. Trimmer head
7. Wheel
8. Control to adjust trimming angle
9. Knob to adjust support handle
10. Support handle
11. Start inhibitor
FIG. 1
USE
INTENDED USE
• The product is intended for trimming grass.
Never use the product for anything other
than the purpose it was designed for. The
product is only intended for household use.
• The charger must only be used with the
type of battery recommended by the
manufacturer.
• The product must only be used as it is
intended to be used. All other use is
considered to be unsuitable.
CHARGING THE BATTERY
NOTE:
• Charge the battery before using it for the
rst time.
• The battery gets warm during the
charging. This is quite normal.
1. Connect the charger to the mains
supply. Only charge at an ambient
temperature of 4 - 40°C. The
recommended optimum charging
temperature is 24°C.
2. Plug the charger into a power point. The
red status light goes on during charging.
3. It takes about 4 hours to fully charge
the battery. The status light goes green
when the battery is fully charged. The
battery reaches full capacity only when
it has been charged and discharged
several times.