Meec tools 011221 - FEEDING OUT THE TRIMMER LINE; ADJUSTING THE WORKING WIDTH

EN
36
and then remove the grass.
WARNING!
Keep your hands, feet and other parts of
your body away from moving parts – risk of
serious personal injury.
Tips
• For best results hold the trimmer head at
a slight angle to the area to be trimmed.
• The product works best when it is moved
from left to right over the area to be
trimmed. It cuts less eectively when
moved from right to left.
• Let the tip of the trimmer line cut the
grass. Do not force the trimmer head into
uncut grass.
• Contact with solid objects, such as
kurbstones, fences, walls and trees,
rapidly wears the trimmer line and
can also break it.
• Avoid contact with trees and bushes. Bark,
fence posts and boarding etc. can easily
become damaged by the trimmer line.
FEEDING OUT THE TRIMMER LINE
NOTE:
The product has automatic feeding of the
trimmer line. Do not tap the trimmer head
against the ground in an attempt to feed out
the line, this will damage the product.
1. Release the speed control while the
product is running.
2. Wait 2 seconds and press the speed
control again. The trimmer line is fed out
about 6 mm each time the speed control
is released and pressed in, until it reaches
the blade on the guard.
3. Continue working.
Manual feeding out of the
trimmer line
1. Remove the battery.
2. Press in the black button on the trimmer
head and pull out the trimmer line by hand.
3. When the line is fed out, return the
product to the normal working position
before starting.
FIG. 7
ADJUSTING THE WORKING WIDTH
1. Remove the battery.
2. Turn the guard to the working position to
prevent cutting plants by mistake.
3. Move the lever for the working width on the
guard to change the working width. There
are two alternatives, 280 and 330 mm.
FIG. 8
NOTE:
The smaller working width increases the run
time and the speed.
MAINTENANCE
WARNING!
Always remove the battery from the product
before cleaning and/or maintenance – risk of
serious injury.
MAINTENANCE
• Always check before use that no parts are
damaged, missing or worn. Firmly tighten
all screw unions. Do not use the product if
any parts are missing or damaged – risk
of serious personal injury. Have the
product checked and repaired before
using it again.
• Do not use solvent on plastic parts, this
can damage the plastic. Remove any dirt,
dust, oil or grease with a clean cloth.