EasyManua.ls Logo

Meec tools 015259 - Description; Technical Data

Meec tools 015259
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN
19
Cord length 1 m
Inlet connection 1"(R25)
Outlet connection 1" (R25)
Size L44 x W22 x H31.5 cm
Weight 15 Kg
L
pA¹
70.6 dB(A), K=2.2 dB
L
wA²
83.1 dB(A), K= 2.2 dB
L
wA³
85 dB(A)
¹
Sound pressure level
²
Measured sound power level
³
Guaranteed sound power level
Always wear ear protection.
The declared values for vibration and noise, which
have been measured according to a standardised
test method, can be used to compare dierent
tools with each other and for a preliminary
assessment of exposure. The measurement
values have been determined in accordance
with ENISO 3744:1995.
WARNING!
The actual vibration and noise level when
using tools may dier from the specied
maximum value, depending on how the
tool is used and the material. It is therefore
necessary to determine which safety
precautions are required to protect the user,
based on an estimate of exposure in actual
operating conditions (taking into account all
stages of the work cycle, e.g. the time when
the tool is switched o and when it is idling,
in addition to the start-up time).
DESCRIPTION
Energy-saving fully automatic hydrophore
pump that with its 600 W delivers an
impressive ow of 3100 l/h and is perfect for
a fully automatic water supply or circulation
under constant pressure. Complete with
manometer. Max water temperature 35°C.
the product is not run without liquid.
Do not pump aggressive liquids or
abrasive material.
Do not pull the power cord or oat switch
cord to move the product, and do not use
them to secure the product from moving.
The product is only intended for
household use and is not suitable for
commercial purposes.
The manufacturer cannot accept liability
for personal injury or material damage
resulting from improper use.
The product is intended to be used with a
domestic water tank. When the pump is
used to boost pressure, the maximum
inlet pressure to the pump (1.0 bar) must
not be exceeded.
IMPORTANT:
The product must be connected to the mains
with a residual current device of max 30 mA.
SYMBOLS
Read the instructions.
Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.
TECHNICAL DATA
Rated voltage 230 V
~
50 Hz
Nominal input power 1300W
Pump pressure 3 bar
Tank volume 24 l
Flow 70 l/min
Lifting height max 50 m
Suction height max 8 m
Water temperature max 35°C
Ambient temperature max 40°C
Protection rating IPX4

Related product manuals