EN
91
change is registered.
3. Connect the product to a computer with a USB cable,
transfer the data and create a feedback le (an upgrade le
must rst be downloaded from the AUTOPHIX website to the
computer).
FIG. 39
4. Select Update.exe, the following display image is shown:
FIG. 40
5. Click on Feedback, the following display image is shown:
FIG. 41
DEVICE INFORMATION
Click on Device Information, the following display image is
shown:
FIG. 42
DEVICE UPDATING
Connect the product to the computer with a USB cable.
• The updating software is only supported by Windows 7, 8
and 10.
• Windows 8 and 10 can run the updating software directly,
but a drive routine must be installed for Windows 7.
To Next Page
Loading...
