EN
59
adjustments, maintenance and/or replacing
accessories.
1. Turn the robot lawn mower upside down.
2. Unscrew and remove the battery cover.
FIG. 19
3. Carefully lift out the old battery. Press the
catch and release the battery connections.
NOTE: Do not pull the wires. Hold the
connections and press the catch.
FIG. 20
4. Connect a new battery by pressing the
connections into place until they click into
locked position.
5. Insert the battery as illustrated. Replace
the battery cover and rmly tighten the
screws.
IOT AND SOFTWARE
The robot lawn mower is an IoT (Internet of
Things) device. To be able to make maximum
use of its features and ensure it always has the
latest software, it must be connected to the
internet via WiFi 2.4G or Bluetooth 4.0.
The app is an integral part of the robot lawn
mower’s cloud-based control system. Once
connected, the robot lawn mower can access
its schedule data stored in the cloud and can
download the latest software to optimise its
performance.
Preparation
• Download the robot lawn mower’s free
app for Android (4.4.2 or later) or from
App store (iOS 11 or later).
FIG. 21
• Check that you have your WiFi password
and the robot lawn mower’s serial
number, which you nd under the rear
cover. Instead of entering the serial
number, you can scan the QR code using
your phone camera.
• Make sure the robot lawn mower and the
phone are in the same signal range of the
router.
• Place the robot lawn mower, phone and
router as close together as possible when
connecting.
• When the robot lawn mower moves into a
zone where the WiFi signal is weak or
does not reach, the instructions sent from
the app will be executed when the mower
returns to a zone with good signal
strength.
App and connection registration
1. Registering your account.
2. Enter the lawn mower’s QR code.
3. Enter the lawn mower’s default password,
0000.
4. Connect to the network (WiFi).
MAINTENANCE
The robot lawn mower operates in demanding
conditions and is exposed to considerable
wear and tear. It must therefore be regularly
cleaned, inspected and worn parts must be
replaced. Turn o the robot lawnmower and
wait until all moving parts have come to a
complete standstill before carrying out any
service or maintenance work. Follow the
instructions for maintenance below.
SOFTWARE UPDATES
The software can be updated when new
versions become available. The latest software
can be downloaded from our website: www.
sk-robot.com. Update via USB. See below for
download and installation instructions.
1. Find the latest software version at: www.
sk-robot.com. Save the le to an empty
FAT32 formatted USB ash drive. Delete
any other les on the drive. If the drive
To Next Page
Loading...
