Meec tools 025269 - Assembly; To Assemble the Product; The Grass Catcher

47
3 Assembly
3.1 To assemble the product
Caution! Do not connect the battery until all parts are
assembled.
1 Do a check that all parts are included.
2 Attach the lower handle (A) into the unit body, lock in
place with the locking knob (B). (Figure 2)
3 Connect the upper (A) and the lower handle (B) and
lock them together with the locking knob (C) as
shown in the illustration. Do not forget to attach the
cable clamp (D). (Figure 3)
4 Attach the handle on the grass catcher. (Figure 4)
5 Fix the grass catcher on the catcher support (Figure
5A, 5B) Pull down the bag of the grass catcher so that
it remains open before you attach it to the product.
(Figure 5C)
6 Open the rear cover and attach the grass catcher.
(Figure 6)
3.2 The grass catcher
● The grass catcher has an indicator which shows if the
bag is full. (Figure 7)
A. When the indicator falls down (during operation),
the grass catcher is full. Turn o the product and
empty the bag.
B. When the indicator is open (during operation), the
grass catcher is not empty or not full.
4 Operation
Warning! Do not use the product in the rain.
● Operate the machine only in daylight or in good artificial
light.
● Avoid operating the machine in wet grass.
● Always be sure of your footing on slopes.
● Walk, never run.
● Mow across the face of slopes, never up and down.
● Exercise extreme caution when changing direction on
slopes, risk of tripping.
● Do not mow excessively steep slopes.
● Use extreme caution when reversing or pulling the
machine towards you.
● Stop the blade(s) if the machine has to be tilted for
transportation when crossing surfaces other than grass,
and when transporting the machine to and from the area
to be used.
● Never operate the machine with defective guards or
shields, or without safety devices, for example deflectors
and/or grass collector, in place.
● Switch on the motor carefully according to instructions
and with feet well away from the blade(s).
● Do not tilt the machine when switching on the motor,
except if the machine has to be tilted for starting. In this
case, do not tilt it more than absolutely necessary and lift
only the part, which is away from the operator.
● Do not start the machine when standing in front of the
discharge opening.
● Do not put hands or feet near or under rotating parts.
Keep clear of the discharge opening at all times.
● Do not transport the machine while the power source is
running.
● Stop the machine, and remove the disabling device. Make
sure that all moving parts have come to a complete stop:
• whenever you leave the machine,
• before clearing blockages or unclogging chute,
• before checking, cleaning or working on the machine,
• after striking a foreign object. Inspect the machine for
damage and make repairs before restarting and
operating the machine; if the machine starts to vibrate
abnormally (check immediately),
• inspect for damage,
• replace or repair any damaged parts,
• check for and tighten any loose parts.
● Make sure the switch button is in OFF-position before the
battery pack is connected.
● Make sure that there are no children or animals nearby
before you start.
● Make sure the battery you are going to use is fully
charged.
● Adjust the cutting height of the product to an applicable
height. The recommended cutting height for mowing is
1/3 of the grass length.
● Walk slower with the product when you cut a lawn that is
thick and high. It might be necessary to cut the lawn in 2
passes. Lowering the blade another 1/3 of the height of
the grass on the second cut.
● The product should always be operated at full throttle to
get the best result, it also allow it to do the most eective
job of mowing.