ENGLISH
27
ELECTRICAL SAFETY
Mains connection
Only use earthed outlet sockets with an earth conductor connected by an expert.
Replacing the power cord
The power cord may only be replaced with a special cord which must be installed by qualified personnel.
Replacing cords or plugs
Throw away old cords or plugs immediately once they have been replaced with new ones. It is dangerous
to connect a loose cord plug to an outlet socket.
Use of extension cords
Only use approved extension cords that match the capacity of the machine. Cores must have a cross
section of at least 1.5 mm
2
. If the cord is attached to a reel, it must be rolled out fully.
SPECIAL SAFETY PRECAUTIONS
Wear protective glasses and a breathing mask.
This figure saw is designed for indoor use only.
Make sure that the saw teeth point downwards before turning on the machine.
If the saw blade has no teeth, or if they are damaged, the saw blade must be replaced immediately.
Use the figure saw on a firm and level surface.
Never push sideways against the saw blade. It can break.
Make sure that the workpiece contains no nails, etc. If it does, these must be removed.
Do not touch the cut surface with your hands.
Never leave the figure saw unattended while it is turned on.
Never remove pieces of wood, etc. with your hands in the vicinity of the saw when it is running.
Stop the machine before removing sawdust and other debris.
INTRODUCTION
Read these Operating Instructions carefully before using the machine. Familiarise yourself with its
functions and use. Maintain the machine according to the instructions, so that it always works perfectly.
The Operating Instructions and related documentation must be kept close to the machine.
This figure saw is perfect for making toys, puzzles, games, jewellery and for fret sawing. The large cutting
capacity makes it a handy do-it-yourself tool. It can cut wood up to 40 mm thick and plastic and non-
ferrous metals.
TECHNICAL DATA
Wear hearing protection!
The declared vibration value, which has been measured by a standardised test method, can be used to
compare different tools with each other and for a preliminary assessment of exposure.
WARNING!
The actual vibration level when using power tools may differ from the specified maximum value,
depending on how the tool is used. It is therefore necessary to determine which safety precautions are
required to protect the user, based on an estimate of exposure in actual operating conditions (taking into
account all stages of the work cycle, e.g. the time when the tool is switched off and when it is idling, in
addition to the start-up time).
To Next Page
Loading...