Meec tools 721-438 - Gearbox Maintenance; Storage

EN
63
3. Assemble the new rotating blades by following the instructions in the reverse order.
NOTE: Side discs (pos. 1, g. 16) should be disassembled and assembled the same way.
GEARBOX MAINTENANCE
WARNING: Do not tilt the gearbox and do not put it on the side or upside down.
Gearbox oil should be changed every year.
Position the machine with the rotating blades and wheels on a level, stable horizontal surface. Depending on the design of the oil ller hole,
unscrew the cap using a hex key (sold separately) (g. 17) and check that the oil reaches the lower edge of the lling hole. Top up the oil, if
necessary and ret the cap.
WARNING: Do not slip the clutch, so that the rotating blades stop temporarily even though the engine is running - risk of overheating
the clutch.
STORAGE
DANGER! The fuel and fuel vapours are ammable and can explode.
WARNING: Do not tilt the machine and do not put it on the side or upside down.
60 cm
16
1
2
3
3
17