To insert a new battery pack, align the grooves on both ends of the
connector (board & battery pack).
Insert, connect, and adjust the two ends of the connector together. Make
sure to tighten the connector to make a good seal.
Ensure the connector lays flat within the accessory wire and the groove
of the board.
Replace and tighten the bolts with the hex wrench, and put the grip tape
back on.
1010
Replace the Battery Pack
11
More Information Online
This manual is a quick start guide intended for someone with little experience
in riding electric skateboards. If you want to learn more on how to start riding,
superior riding skills, and solutions for riding problems, please visit our website:
www.meepoboard.com or send us an email at info@meepoboard.com.
GETTING STARTED
How to stand on the board
How to turn
How to find a good spot to practice
ADVANCED TECHNIQUES
How to footbrake
How to ride uphill and downhill safely
What to look for when riding through traffic
MAINTENANCE
Pre-ride inspection
Routine maintenance
WARNING!
Whenever riding a electric skateboard, make safety your top priority.
Loss of control, collisions, and falls may cause serious injury to you.
Please ride responsibly and respect those around you. How you ride will
determine how people view this new mode of transportation.
WARNING: AVOID WATER!
WARNING: PINCH POINTS
WARNING: RISK OF ELECTRIC SHOCK!
WARNING:
WARNING:
Always wear a helmet when riding. Never ride in the rain, or on wet,
slippery or uneven surfaces with steep hills, traffic, cracks, train tracks,
gravel, rocks or any obstacles that could cause a loss of traction. Avoid
night riding in areas with poor visibility or narrow spaces.
WARNING:
Riding in wet conditions or through puddles can
damage the board’s electronics and cause the board
to lose power or stop suddenly. Damage to the board
due to water exposure is not covered under the
warranty.
Keep fingers, hair, and clothing away from motors,
wheels, and all moving parts.
Do not open or tamper the case or battery with
cleaning products, this will void the board’s warranty.
This equipment has been tested and complies with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and
radiates radio frequency energy. If not installed and used in accordance with
the instructions, it may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation.
To Next Page
Loading...
