Mega Lite Mega Air DMX - Connection Procedures; Point to Point Connection; Multi Point Connections; Unlinking Devices

To unlink a Receiver
1.1 Press and hold the Function button on the Receiver for about 5 second until the Connection indicator flashes once and then goes off. Now the Receiver is
unlinked
8
Connection
Point to Multi Point Connection
1.1 Connect the Transmitter to power, the connection button should be flashing green.
1.2 Connect DMX signal into the Transmitter, the connection button should be green.
1.3 Connect the Receiver to power, the connection indicator should be off ( if the receiver connection light is not off you need to unlink your receiver)
1.4 Press and quickly release the Function button on the Transmitter. The transmitter will scan for all unlinked receivers for a period of 10 seconds– the
connection indicator on both Transmitter and Receiver will flash rapidly.
1.5 If the connection is successful the Connection indicator on the Transmitter and Receiver will be green on. If the connection indicator is not on Green, check
that the Receiver is in range and repeat the procedure.
Multi Point to Multi Point Connection
1.1 Connect the First Transmitter to power, the connection button should be flashing green.
1.2 Connect DMX signal into the First Transmitter, the connection button should be green.
1.3 Connect the Receiver(s) to power, the connection indicator should be off ( if the receiver connection light is not off you need to unlink your receiver)
1.4 Press and quickly release the Function button on the First Transmitter. The transmitter will scan for all unlinked receivers for a period of 10 seconds– the
connection indicator on both Transmitter and Receivers will flash rapidly.
1.5 If the connection is successful the Connection indicator on the Transmitter and Receiver will be green on. If the connection indicator is not on Green, check
that the Receiver is in range and repeat the procedure.
1.6 Connect the Second Transmitter to power, the connection button should be flashing green.
1.7 Connect DMX signal into the Secound Transmitter, the connection button should be green.
1.8 Connect the Receiver(s) to power, the connection indicator should be off ( if the receiver connection light is not off you need to unlink your receiver)
1.9 Press and quickly release the Function button on the Secound Transmitter. The transmitter will scan for all unlinked receivers for a period of 10 seconds
the connection indicator on both Transmitter and Receivers will flash rapidly.
1.10 If the connection is successful the Connection indicator on the Transmitter and Receiver will be green on. If the connection indicator is not on Green, check
that the Receiver is in range and repeat the procedure.
1.11 You can repeat the process up to 16 Transmitters.
To unlink all Receiver
1.1 Press and hold the Function button on the Transmitter for about 5 second until the Connection indicator flashes once and then goes off. Now the Receivers
are unlinked
Point to Point Connection
1.1 Connect the Transmitter to power, the connection button should be flashing green.
1.2 Connect DMX signal into the Transmitter, the connection button should be green.
1.3 Connect the Receiver to power, the connection indicator should be off ( if the receiver connection light is not off you need to unlink your receiver)
1.4 Press and quickly release the Function button on the Transmitter. The transmitter will scan for all unlinked receiver for a period of 10 seconds– the
connection indicator on both Transmitter and Receivers will flash rapidly.
1.5 If the connection is successful the Connection indicator on the Transmitter and Receiver will be green on. If the connection indicator is not on Green, check
that the Receiver is in range and repeat the procedure.