31
Uninterruptible power supply MEg102
Mechanically, the power supply unit MEg102 is to be placed close to the measuring
instrument mounted on the DIN rail TC 35 using a clip. e power supply unit can be
also just put on the horizontal surface.
e vents of the unit MEg102 are not allowed to be covered. During installation, it is
necessary to respect IP20 protection.
When the uninterruptible power supply MEg102 is used in a dierent way
than it is specied by the manufacturer, the protection provided by the power
supply unit MEg102 can be impaired.
5/ MAINTENANCE INSTRUCTIONS
e uninterruptible power supply units MEg102 do not contain any movable parts, and
therefore do not require any mechanical maintenance other than common cleaning. To
clean you can only use soft materials and non-aggressive solutions. In rough industrial
conditions, it is necessary to check that the vents are open through. e instrument
includes maintenance-free accumulator NiMH batteries that shall be replaced after
10years of operation as recommended by the manufacturer and then the power supply
unit checked for correct operation.
6/ MANUFACTURER
MEgA – Měřící Energetické Aparáty, a.s.
664 31 Česká 390, Czech Republic
tel: +420 545 214 988 • mail: mega@e-mega.cz • web: http://www.e-mega.cz
To Next Page
Loading...