GENERAL SAFETY RULES
1. ALWAYS read and understand the manual before installing and commissioning the fireplace.
2. ALWAYS ensure the fireplace is installed in accordance with local regulations.
3. ALWAYS ensure that the fireplace is correctly installed and positioned as described in the
diagram on page 7, and that the immediate area is kept clear.
4. ALWAYS check for damage before using the fireplace. Check for breakage of parts and any
other condition that may affect the fireplaces performance. Any damage should be properly
repaired or the part replaced. If in doubt, DO NOT use the fireplace. Consult your local dealer.
5. ALWAYS keep children and visitors at a safe distance from the fireplace.
6. NEVER direct any kind of liquid on to the fireplace, particularly when it is hot.
7. NEVER use gasoline or other flammable liquids for fire starting.
8. NEVER use the fireplace to incinerate materials other than recommended fuels.
9. NEVER carry out any modifications to this product. If experiencing difficulty of any kind
consult your local dealer.
10. The installation of the fireplace and chimney MUST comply with all local building
regulations. It is the responsibility of the owner and the installer to ensure that the installation
complies.
11. All rooms where a fireplace is situated must have a non-motorized air vent (air brick). Refer
to details contained in the Building Regulations.
UNPACKING & ASSEMBLY
UNPACKING
Before assembling, please check contents against the following list and advise your dealer
immediately if any parts are missing. Do not install this product if any parts are missing or found
to be damaged or defective.
TOOLS REQUIRED
Phillips screwdriver
Adjustable spanner
Fire Cement / Heat-resistant silicone
Pop-rivets or Self-tapping screws
Water-proofing / Roof sealant
To Next Page
Loading...
