burner ports.
To clean the burner ports, remove the reflector assembly by removing the three nuts at the
top of the reflector. The mesh screen should then be extracted by removing the four
retention screws at the base of the mesh screen and four screws at the top of the screen.
Remove the two screws retaining the burner assembly, rotate the burner assembly slightly
then remove the burner assembly upwards.
Care should always be taken to avoid damage to the gas piping and Piezo ignition lead.
The burner and mesh screen should then be cleaned by compressed air. Assembly is a
reversal of the above procedure.
If the pilot is blocked by debris, spider webs etc. the pilot flame may be small and the flame
failure device may have not heated up enough for the main burner to come on. If this
happens it will be necessary to clean the pilot and its gas tube.
To clean the pilot, remove the burner and pilot cover as detailed above, Inspect the pilot
injector and tubing for blockage. If obstructed clean with compressed air. Clean the flame
failure device. Assembly is a reversal of the above procedure.
TECHNICAL INFORMATION
• ?:3C.!-R.!W6:W.!3H!-R.!I6C!VA:7@2.4!6H-.4!1C.S!
• >.62!-R.!7@C-41V-73@C!X.H34.!1C7@I!-R7C!6GG:76@V.S!
• Y34!1C.!31-2334C!6@2!7@!Z.::!W.@-7:6-.2!64.6CS!
• FR.!1C.!3H!-R7C!6GG:76@V.!7@!.@V:3C.2!64.6C!V6@!X.!26@I.431C!6@2!7C!5>08,[,F\BS!
• FR7C!6GG:76@V.!/1C-!X.!7@C-6::.2!6@2!6CC./X:.2!7@!6VV3426@V.!Z7-R!9E;9!"$&*<#+"#S!
• E!Z.::PW.@-7:6-.2!64.6!/1C-!R6W.!6!/7@7/1/!3H!#&]!3H!-R.!C14H6V.!64.6!3G.@S! !
• FR.!C14H6V.!64.6!7C!-R.!C1/!3H!-R.!Z6::C!C14H6V.S!
To Next Page
Loading...