replaced before operating the heater.
• Change the gas cylinder in a well-ventilated area, away from any ignition source.
• Check that the regulator seal is fitted and that it is in good condition.
• Do not obstruct the ventilation holes of cylinder housing.
• Adults and children should stay form high temperature surface to avoid burns or
clothing ignition.
• Children should be carefully supervised when they are in the area of the heater.
• Clothing or other flammable materials should not be hung on the heater or placed
on or near the heater.
• The user may replace the rubber hose by himself/herself and must not be longer
than 60cm. The hose must be suitable for LP Gas and comply with SANS 1156.
LP Gas Characteristics - Flammable, explosive, heavier than air-settles in low areas.
In its natural state, LP Gas has no odor. For your safety, an odorant is added to assist in
leak detection.
• Contact with liquid LP Gas can cause freeze burns to skin.
• This heater is shipped from the factory for use with LP Gas only.
• Use only an approved ”9kg” LP Gas cylinder (same as commonly used on gas grills)
with safety valves.
• Never use a cylinder with a damaged body, valve, collar or foot ring.
• When heater is not in use, turn Control Valve OFF. Close the valve of the gas
cylinder or the regulator after use.
• The use of this appliance in enclosed areas can be dangerous and is
PROHIBITED.
1) For use outdoors or in amply ventilated areas.
2) An amply ventilated area must have a minimum of 25% of the surface area open.
3) The surface area is the sum of the walls surface.
To Next Page
Loading...