Megger MT0300 - Page 25

Operating the MTO
AVTMTO3XX Rev 3 Sept 2013
17
 Follow the instructions on the screen or download the detailed instruction
set for print. The software and instructions will guide you thru a step by step
process of selecting the Ethernet Interface, verifying that the MTO is
connected, power cycling the MTO to synchronize the boot loader with the
PC, selecting the file for download and downloading the firmware to the
instrument.
 At the end of the process, the software should display Successful download.
 The unit will have to be power cycled to exit boot loader mode.
ATTAINING THE POWERDB SOFTWARE:
The best way to attain the latest software is to visit Megger.com. Once you are on the
site:
 Select the country you are located in.
 You may have to register to log in on the site.
 Select Software Downloads.
 Select the PowerDB link
 Download the instruction file and print before any other steps are followed.
 Read the instruction carefully.
 Follow the instructions step by step to assure the process completes fully and
successfully.
 At the end of the Update process, the unit should be ready for testing.