EasyManuals Logo

Megmeet MTC-08-NT User Manual

Default Icon
58 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #53 background imageLoading...
Page #53 background image
53
download from the right-click menu to complete the setup.
6.3 the setting
Example: MTC station number is 2. Set the first channel to use mode 3, work in the heat mode, the given
value is 100.0, the control cycle is 3 seconds, use the self-tuning mode, the self-tuning deviation is set
to -20.
1. Refer to the 6.1 feature to change the first three steps for setting
2. Select the control function and set it according to the figure below.
Figure 6-9 setting the control function
3. Right-click the site 2 option under the module configuration in the left tree structure, and select
download from the right-click menu.
4. Click menu monitor -> to start monitoring.
5. Click chart monitor and select 1 from the self-tuning start/stop of the corresponding channel. Start,
click ok in the dialog box that pops up, wait a few seconds, self-tuning start/stop will change from stop to
start, start self-tuning, until finished, self-tuning start/stop will change from start to stop, the thermostat
will continue to run after self-tuning parameters.
Figure 6-10 Confirm start self - tuning
6.4 Multi-step setting
Example: MTC station number is 2. The first channel is set to use mode 3, work in heat mode, control
cycle is 3 seconds, proportional band is 20, integral time is 60, differential time is 15. See table 6-1 for the

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Megmeet MTC-08-NT and is the answer not in the manual?

Megmeet MTC-08-NT Specifications

General IconGeneral
BrandMegmeet
ModelMTC-08-NT
CategoryThermostat
LanguageEnglish