Need help?Do you have a question about the MEI CASHFLOW 2612 and is the answer not in the manual?
General| Type | Banknote Validator |
|---|---|
| Interface | RS-232, USB |
| Power Supply | 12VDC or 24VDC |
| Acceptance Rate | 98% or greater |
| Operating Voltage | 12VDC or 24VDC |
| Power Consumption - Standby | < 5W |
| Supported Currencies | Configurable, multi-currency support |
| Operating Temperature | 0°C to +60°C |
| Note Size - Width | 62 - 85 mm |
| Note Width | 62 - 85 mm |
| Stacker Capacity | 200 notes |
Describes compliance with IEC/EN standards for safety and equipment performance.
Specifies the operating voltage and the requirement to use the indicated power source only.
Prohibits operation in environments with flammable gases, fumes, or water.
Introduces the handbook's content on installing, operating, and maintaining note acceptors.
Briefly describes the Cashflow® 2612's purpose and features in vending applications.
Provides a general overview of the Cashflow® 2612 Engineers Guide's scope and purpose.
Summarizes the Cashflow® 2612's design for vending applications in Europe and acceptance types.
Lists key features of the Cashflow® 2612 note validator, including currency support and interface options.
Details the power requirements for the Cashflow® 2612 unit, including voltage and amperage.
Lists part numbers for kits used to convert between different bezel styles on the note acceptor.
Describes a locking hasp kit available to secure side doors on specific note magazines.
Details the MDB cable, its part number, and provides a wire chart for connections.
Provides instructions for unpacking and inspecting the note acceptor for damage upon arrival.
Details the process and considerations for physically mounting the note acceptor within a machine.
Describes setting the highest acceptable banknote value within the unit's Service Mode.
Notes on the behavior of the note acceptor with specific software versions and the STS tool.
Recommendations for payout settings on changers when using a note acceptor for optimal performance.
Outlines the essential steps for testing the note acceptor's functionality after installation.
Details the two-year manufacturer's warranty, covering inspection, service, and repair information.
Describes the default configuration settings programmed at the factory and how they are overridden.
Details specific switch settings for the Euro version of the Cashflow® 2612.
Explains how to set note acceptance directions (one, two, or four-way) using the coupon.
Describes setting acceptance or security parameters for individual note denominations via coupon.
Explains how to set pulse timing and select interface types (AC/High Level) using the coupon.
Details how to set the required number of pulses per Euro for standard interface configurations.
Explains how to configure bezel light behavior (ON or Flashing) based on bezel style.
Describes the sequence of events from note detection to storage during the acceptance process.
Details the IHLP interface, its voltage usage, limitations, and exact change condition monitoring.
Details the ILLP interface, its DC voltage usage, note escrow support, and exact change monitoring.
Details the MDB interface protocol for bi-directional serial communication with note acceptors.
Provides step-by-step instructions for safely cleaning the note acceptor while it is mounted.
Shows an exploded view and lists parts for the chassis assembly of the Cashflow® 2612.
Shows an exploded view and lists parts for the LED housing assembly of the Cashflow® 2612.
Shows an exploded view and lists parts for the sensor assembly of the Cashflow® 2612.
Shows an exploded view and lists parts for the stacker/drive assembly of the Cashflow® 2612.
Shows an exploded view and lists parts for the magazine assembly of the Cashflow® 2612.
Shows an exploded view and lists parts for the gearbox assembly of the Cashflow® 2612.
To Next Page
