Need help?Do you have a question about the MEI SC Advance and is the answer not in the manual?
General| Type | Bank Note Validator |
|---|---|
| Manufacturer | MEI |
| Model | SC Advance |
| Interface Options | Serial, USB |
| Power Supply | DC |
| Operating Voltage | 12V DC / 24V DC |
| Communication Interface | Serial, USB |
Details product, cassette size, bill path width, interface, and description parameters for CASHFLOW SC/SC Advance.
Explains the codification system for serial numbers including manufacture week, year, location, and production number.
Identifies the three main components of the note acceptor: Cashbox/LRC, Acceptor Module, and Chassis.
Lists standby, acceptance, and stacking power requirements, as well as input voltage for the note acceptor.
Details connecting the PPM handheld device to the note acceptor via USB cable for software updates.
Explains how to replace the programmed PROM (chip change) for software updates, disabling PPM downloads.
Step-by-step guide on how to remove and clean the note acceptor module, including the note path and sensor areas.
States that CASHFLOW SC® and SC Advance® models are designed not to require calibration.
Lists flash codes for the two green LEDs on the bezel and their corresponding reasons for failure.
Explains the meaning of red, yellow, and green LED conditions for faults and normal operation.
Details diagnostic codes related to EASITRAX Soft Count, including RF tag status and asset number mismatches.
To Next Page
