MEI CASHFLOW SC / SC Advance Page-7
UPDATING SOFTWARE
Using the PPM (Continued):
PPM Download Procedure:
After connecting the PPM to the note acceptor with the USB cable, you may begin downloading.
1. Press the square download button located on the front of the PPM. (see g.2 on previous page).
2. While downloading, a solid green LED and ashing red LED on the front of the PPM will
indicate the device is busy.
3. Both green and red LEDs on the PPM will light up solidly when the download has nished
successfully. The note acceptor will then perform a run and stack, and the LEDs on the PPM will
turn off. At this point, the USB cable may be disconnected from the note acceptor.
5. Following a successful download, the diagnostic LEDs on the note acceptor will ash green
until communication between the note acceptor and the machine is re-established.
To Next Page
Loading...
Need help?
General
